Siemens SIMATIC S7-1500/ET 200МР Manual page 57

Configuring/address space
4.4 Fast Mode
Parameter setting using...
Hardware configuration with GSD
file for distributed operation on
PROFIBUS DP
Parameters of the TM Count 2x24V
The following parameter settings are possible. The default settings of the parameters are
shown in bold in the "Value range" column.
Table 4- 11
Reaction to CPU STOP
Substitute value for DQ0
Substitute value for DQ1
Enable diagnostic interrupt on
wire break
Enable additional diagnostic
interrupts
Signal type
Invert direction
(counter inputs)
56
Basic procedure
1. Install the current PROFIBUS GSD file.
You will then find the module in the hardware catalog under "Other field devices
> PROFIBUS DP > I/O".
2. Set the parameters in the hardware configuration.
The parameters marked with
PROFIBUS GSD file.
3. Download the project to the CPU.
The parameters marked with
default setting.
4. If necessary, set the parameters marked with
record 128.
Configurable parameters
Parameter
1
•
•
•
1
•
•
1
•
•
•
2
•
•
•
•
•
•
•
•
1
•
•
in the following tables are not configurable in the
1
in the following tables are downloaded with their
1
Value range
Output substitute value
Keep last value
Continue operation
0
1
0
1
Deactivated
Activated
Deactivated
Activated
Pulse (A)
Pulse (A) and direction (B)
Count up (A), count down (B)
Incremental encoder (A, B phase-shifted)
Incremental encoder (A, B, N)
Deactivated
Activated
Technology module TM Count 2x24V (6ES7550-1AA01-0AB0)
Equipment Manual, 12/2020, A5E31870371-AC
in the user program using data
1
Scope
Channel
Channel
Channel
Channel
Channel
Channel
Channel