Chapter 5 Display And Setting Of Various Functions; List Of Function - SMC Networks HRSH090 Series Operation Manual

Chapter 5
Read and understand this manual carefully before changing the
settings.

5.1 List of function

NO Function
Displays the current temperature of the circulating fluid, discharge pressure of
1 Main display
the circulating fluid change the circulating fluid temperature.
Alarm display
2 Indicates alarm number when an alarm occurs.
menu
Inspection Product temperature, pressure and accumulated operating time can be
3
checked as daily inspection. Use these for daily inspection.
monitor menu
4 Key-lock Keys can be locked so that set values cannot be changed by operator error.
Timer for
5 operation start Timer is used to set the operation start/stop.
/stop
Signal for the
A signal is output when the circulating fluid temperature reaches the set
6 completion of
temperature, when using contact input/output and serial communication.
preparation
Use this function when there is a temperature offset between the discharge
7 Offset function
temperature of the thermo-chiller and the customer's device.
Reset after
8 Start operation automatically after the power supply is turned on.
power failure
Key click sound
Operation panel key sound can be set on/off.
9
setting
Changing temp. Temperature unit can be changed.
10
unit Centigrade(
Changing Pressure unit can be changed.
11
MPa⇔PSI
pressure unit
Functions can be reset to the default settings (settings when shipped from the
12 Data reset
factory).
Accumulation Reset function when the pump, the fan or the compressor is replaced. Reset the
13
accumulated time here.
time reset
Pump operation The fluid supply mode of the pump can be changed
14
Pressure control mode ⇔ Frequency set mode
mode set
Anti-freezing Circulating fluid is protected from freezing during winter or night.
15
function Set beforehand if there is a risk of freezing.
Warming up When circulating fluid temperature rising time at starting needs shortening
16
during winter or night, set beforehand.
function
Setting of alarm
17 Alarm sound can be set to on/off.
buzzer
Alarm Operation during alarm condition and threshold values can be changed
18
depending on the alarm type.
customizing
This function is used for contact input/output or serial communication.
19 Communication
HRSH Series
Display and setting of
various functions
The product can have the displays and settings shown in Table 5-1.
Table 5-1 List of function
o o
C) ⇔ Fahrenheit(
Chapter 5 Display and setting of various functions
Outline
F)
HRX-OM-R026
Reference
page
5.3
5.4
5.5
5.6
5.7
5.8
5.9
5.10
5.12
5.13
5.14
5.15
5.16
5.17
5.11
5.18
5.19
5.20
5.21
5.1List of function
5-1