Operation Display Panel - SMC Networks HRSH090 Series Operation Manual

2.4 Operation display panel

No Description
Digital display
①
(7 segment,
4 digits)
o o
②
[ C F ] lamp
③
[MPa PSI] lamp
④
[REMOTE] lamp
⑤
[RUN] lamp
⑥
[ALARM] lamp
⑦
[ ] lamp
⑧
[ ] lamp
⑨
[ ] lamp
⑩
[RUN/STOP] key
⑪
[MENU] key
⑫
[SEL] key
[▼] key
⑬
[▲] key
⑭
⑮
[PUMP] key
⑯
[RESET] key
HRSH Series
The operation panel on the front of the product controls the basic operation
of the product.
Fig. 2-4 Operation display panel
Table 2-4 Operation display panel
Displays the temperature and pressure of the circulating
PV
fluid and alarm codes.
Displays the set temperature of the circulating fluid and
SV
the set values of other menus.
Displays the unit of display temperature (
Displays the unit of display pressure (MPa or PSI).
Lights up during remote operation by communication.
・Lights up when the product is started and in operation. Goes off when the
product is stopped.
・Blinks during stand-by for stop (Interval 0.5 seconds).
・ Blinks during independent operation of the pump (Interval 0.3
seconds).
・Blinks during anti-freezing function (At standby: Interval 2 seconds, At
operation: Interval 0.3 seconds).
・Blinks during warming up function (At standby: lit on for 0.5 seconds
and off for 3 seconds, At operation: interval 0.3 seconds.)
Flashes with buzzer when alarm occurs (Interval 0.3 seconds).
Lights up when the fluid level lowers.
Lights up while the run timer or stop timer function is working.
Lights up when the product is in automatic operation.
Makes the product start or stop.
Shifts the main menu (display screen of temperature) the other
menu (entry of set values and monitor screen).
Changes the item in menu and enters the set value.
Decreases the set value.
Increases the set value.
When the [MENU] and [RUN/STOP] keys are held down
simultaneously, the pump starts running independently.
Press the [▼] and [▲] keys simultaneously. This will stop the alarm
buzzer and reset the [ALARM] lamp.
Keep the [▼] and [▲] keys pressed down simultaneously for 3
seconds to reset AL46 and AL48.(After resetting AL48,
WAIT( ) will be displayed and the product cannot run for 40
seconds. Restart 40 seconds later after resetting.
Chapter 2 Name and Function of Parts
Function
o o
C or
F).
HRX-OM-R026
Reference
page
5.3
5.13
5.14
5.21
4.4
5.4
4.3
5.7
5.10
4.4
5.2
-
4.3
7.3
2.4Operation display panel
2-5