Loading Media Wit H T He Cut T Er Opt Ion - Datamax E-Class Mark III Operator's Manual

2 .3 .4 Loa din g M e dia w it h t h e Cu t t e r Opt ion
Load m edia for cut t ing ( if t he print er is equipped wit h t he opt ion) as follows:
1) Load m edia as described in Sect ion 2.3, ( st eps 1- 3) .
2) Rout e t he m edia t hrough t he opening in t he Cut t er.
3) I f using Therm al Transfer m edia ( ribbon) proceed t o Sect ion 2.4 Loading Ribbon. Ot herwise close
t he print er's Cover and press downward unt il lat ched.
4) Press t he
The print er w ill now cut each label as it exit s from t he print er.
7) The print er will now peel each label and present it t o t he operat or for rem oval.

I f t he print er is equipped wit h t he Present Sensor Opt ion,
next label w ill not feed/ print unt il t he previous label is rem oved.

The print er is fact ory set t o use gap m edia. I f using anot her m edia t ype ( for exam ple, cont inuous
m edia) , print er set up m ust be reconfigured; see Sect ion 3.4
1 0
312
but t on several t im es t o advance t he m edia ( if t he Fault Light is lit , see Sect ion 3.7.) .

Cut t er

Media
he indicat or light w ill flash orange and t he
t
.
Ch a pt e r 2 – Pr in t e r Se t u p