Advertisement
24
Installation
General
This section provides information about the
installation and commissioning with regard
to the following:
Required documents
Personnel requirements
Tools, devices, and expendable materials
to be used
Accident prevention
Recording and documentation.
To prevent damage to the RCU, operators should
always use electrostatic discharge ground straps
when operating the equipment if it is in a high-
static environment.
Hazardous voltages.
Will cause death or serious injury.
Do not work on energized equipment. Always de-energize and ground the
lines before working on the equipment.
If live-line work must be performed, follow requirements of local
occupational health and safety regulations and employ personal
protective equipment (PPE) suitable for the voltages involved. It is the
user's responsibility to develop safe and adequate working procedures
complying with these requirements.
Always consider all parts as energized until they are de-energized, tested
for absence of voltage, and grounded.
Installation guidelines
The RCU should be installed on the lower
portion of the pole. The RCU is not
connected to high voltage. Subject to local
utility regulations installation can be
completed by personnel qualified to perform
work on low-voltage installations.
Grounding of the RCU is required in
accordance with the Grounding section on
page 35.
Tools required for installing the RCU
1 x 24 mm box-end wrench
2 x 18 mm box-end wrench
2 x 19 mm box-end wrench
Adjustable torque wrench in range
30 to 50 lb-ft (40 to 70 Nm) with
18 mm, 19 mm and 24 mm sockets
Flat No. 2 screwdriver
Flat No. 1 screwdriver
Cable stripping and termination tools.
Additional parts:
Ground cables and terminals.
Advertisement
