How To Assemble Your Light Kit Or Cap - Fanimation TwoFold LP8551LBN Manual

How to Assemble Your Ceiling Fan Blades (Continued)
4. Position blade side-A under the blade side-B and
align end of the blade holes. Securely tighten the
5/32"-32 flat head screws. (Figure 3)
HARDWARE USED:
5/32"-32
Flat Head Screws

How to Assemble Your Light Kit or Cap

1. Remove one of the three screws in the support
bracket at the bottom of the motor assembly. Retain
the screw for later and slightly loosen the remaining
two screws. (Figure 1)
2. Assemble the light kit to the support bracket using
the two key slots in the light kit. Replace the
previously removed screw and securely tighten all
three screws. (Figure 2)
3. Remove one of the three screws in the light kit.
Retain the screw for later and slightly loosen the
remaining two screws. (Figure 3)
4. If installing the light kit, skip this step.
Assemble the light kit wire cover to the light kit using
the two key slots. Replace the removed screw and
secure all three screws. (Figure 4)
5/32"-32
Flat Head Screws
x 4
13
Blade - Side A
Figure 3
Motor Assembly
Figure 1
Motor
Assembly
Figure 2
Figure 3
Light Kit
Wire Cover
Figure 4
Blade - Side B
Light Kit
Light Kit
Light Kit