How To Assemble Your Ceiling Fan Blades; How To Assemble Your Light Kit Or Cap - Fanimation KWARTET FPS8553 Series Instructions Manual

How to Assemble Your Ceiling Fan Blades

1. Slide blades through slots in motor housing and
attach to the motor hub using the 3/16˝-24 truss head
screw with spring washer/flat washer. Make sure
the screws securing the blades to the motor hub are
tight and are properly seated. (Figure 1)
NOTE: Periodically check blade hardware and
resecure if necessary.
CAUTION
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
WARNING
To reduce the risk of personal injury, do not bend the
blades when installing, balancing or cleaning the fan.
Do not insert foreign objects in between the rotating
blades.

How to Assemble Your Light Kit or Cap

1.
Remove one of the three screws in the support
bracket at the bottom of the motor assembly. Retain
the screw for later and slightly loosen the remaining
two screws. (Figure 1)
Option A--for use with steel cap
NOTE: If installing the light kit, please skip to Step 4.
2.
Assemble the light kit wire cover to the motor
assembly using the two key slots. Replace the removed
screw and secure all three screws. (Figure 2)
3. Assemble the steel cap to the motor assembly by
twisting in a clockwise direction. (Figure 3)
HARDWARE USED:
3/16"-24
Truss Head Screw
With Spring Washer/
Flat Washer
Motor
Assembly
Motor
Assembly
Light Kit Wire
Cover Assembly
Motor
Assembly
Steel Cap
10
Blade
3/16˝-24
Truss Head Screw With
Spring Washer/Flat Washer
(3 each per blade)
Figure 1
X 12
Figure 1
Figure 2
Figure 3