How To Wire Your Ceiling Fan - Fanimation TwoFold LP8551LBN Manual

NOTE: If fan or supply wires are different colors than indicated, have this unit installed by a qualified electrician.
1. To set the code on receiver unit, slide dip switches
to the same positions as set on the remote control.
(Figure 1)
NOTE: The remote unit has 32 different code
combinations. To prevent possible interference from
or to other remote units, simply change the
combination code in the remote and receiver.
NOTE: Factory setting is all up. Do not use this
position.
WARNING
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before wiring.
(Figure 2)
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
2. Slide the receiver into the hanger bracket before
wiring as shown in figure 3.

How to Wire Your Ceiling Fan

Dip Switch
ON
1 2 3
Remote Control
Dip Switch
Receiver
NOTE: Supply wires
omitted for clarity
10
Receiver
4 5
Figure 1
Main Fuse Box
Figure 2
Hanger Bracket
Dip Switch
Figure 3