Table of Contents
Advertisement
7. Test to ensure that the lift can only be driven
away from the obstruction. The LED indicator light
will turn to green and stop beeping indicating a safe
operating condition.
8. Repeat the above tests while driving the lift in
opposite direction.
9. If any safety condition does not function properly,
carefully review all installation instructions, reset the
"ON /OFF" switch and check that the LED indicator
light is green. Repeat the above tests.
10. If any safety stop switch fails to immediately
stop the lift and/or a red LED indicator light appears,
remove the key to prevent further use of the lift and
immediately call the manufacturer for assistance
in diagnosing and repairing the problem. DO NOT
USE THE LIFT.
E. ADDITIONAL SYSTEM CHECKS
1. After the successful testing of all safety switches,
sit on the lift and operate to the top of the stairs.
Keeping the control switch depressed continuously,
the lift should gently decelerate and then stop at
the top of the rail.
2. As a final adjustment, sit on the lift and do two
(2) complete up trips and stop with the chair at
the bottom. Then tighten the compression screw
in the top end plate, then run the chair to the top
and again tighten the compression screw. Run the
chair to the middle and do a final tightening of the
compression screw.
3. Drive the lift to the bottom, keeping the control
switch depressed all the time, and check that the lift
gently decelerates and stops so the footrest pan is
clear of the floor. If necessary adjust the limit cams
with a 5/64" Allen wrench.
4. Move the lift about 3' from either the top or
bottom of the rail. After 30 seconds the armrest
LED indicator light will show orange and beep
indicating that the lift is not positioned on a charge
point. The beep will stop after 30 seconds, but the
armrest LED indicator light will continue to flash
orange.
P/N: 76015 RevE 72618
COMPLETION PROCEDURES
5. Test the seat swivel at the top by using the levers
and swiveling the seat towards the landing and
stop the seat at 35 and 85 degrees. The seat swivel
levers will release into a locked position at each of
these angles. The lift will not operate in any of these
positions if the control switch is depressed, and the
LED indicator light will turn orange. Return the seat
to its normal position and the LED indicator light will
turn green and the lift will now operate normally.
SL600 • Pinnacle Stair Lift Installation Manual
Pinnacle Stair Lift
15
Advertisement
Table of Contents
