Table of Contents
Advertisement
When the 6-pin footrest and/or the 8-pin
chair cables are connected to the chassis,
the black installation switch on the chassis
is disabled and will not function.
TIP
10. Connect the seat cable to the 8-pin connector
on the chassis. [Figure 11-1]
11. The armrest control is factory set for right-hand
operation. If the user prefers to operate the armrest
controls with their left hand, this is how to change:
• Remove screws on both armrests [Figure 11-2]
• Disconnect armrest control harness [Figure 11-3]
• Remove LED connector. Use knife or blade to
remove glue [Figure 11-4]
• Swap armrest harnesses
• Reconnect 6-pin connector [Figure 11-5]
• Connect LED with red wire toward center of seat
(if connected backwards, you will get a red light)
• Reassemble each armrest
12. Turn the red "ON/OFF" switch located on the
NOTE - If the lift is equipped with the optional key
switch on the chassis control, be sure it is in the
locked position [Figure 11-6]
top of the chassis to the "ON" (I) position. You
should hear a single beep and the LED indicator
light on the armrest control should cycle through
a test sequence, showing red, yellow and green
respectively. If any of the system controls or safety
sensors are engaged the LED indicator light will turn
to yellow. [Figure 11-7]
It may be necessary to locate the retractor
portion of the seatbelt on the downward
side of the lift to maintain close distance to
the wall.
TIP
P/N: 76015 RevE 72618
INSTALLATION PROCEDURES
Pinnacle Stair Lift
Figure 11-1
Figure 11-2
Figure 11-3
Figure 11-4
Figure 11-5
Figure 11-6
Figure 11-7
SL600 • Pinnacle Stair Lift Installation Manual
11
Advertisement
Table of Contents
