Table of Contents
Advertisement
Pinnacle Stair Lift
A. DETERMINE OVERALL RAIL LENGTH
(Only if rail did not come pre-cut to length)
1: Determine any obstructions that will affect the
position and length of the rail. These may include
walls, doors, hallway orientation, etc.
2: Measure the overall length of the stairs from the
nose at the top landing of the stairs to the floor at
the bottom (nose to floor measurement, (128").
[Figure 4-1]
3: For a normal stairway with adequate space for a
landing, add 7" to the nose to floor measurement.
This will provide enough rail length to allow
the stair lift to be adjusted so that the floor-to-
seat height will be the same at both the top and
bottom (e.g., 141").
4: If the top landing has restrictions (i.e., a wall or
doorway), use the chart below to determine the
length of extension that should be used.
5: To cut the rail, use a standard 12" chop saw,
with a blade designed to cut aluminum.
Installation Site Electrical Requirements - The lift shall be connected to a dedicated
120V 15A electrical circuit.
4
INSTALLATION PROCEDURES
Do not cut rail inside the house (aluminum
chips are very hard to remove from carpets)
TIP
7 in
9 in
3.9 in
5 in
Horizontal intrusion on top landing
DO NOT cut the end of the rail that contains the joint holes.
Remove the charger strips and wire harness before cutting.
TIP
| www.harmar.com
Extension
11 in
6.1 in
Figure 4-1
13 in
7.2 in
© 2018Harmar Mobility, LLC • All Rights Reserved
Advertisement
Table of Contents
