Table of Contents
Advertisement
PINNACLE HD STAIR LIFT: SECTION 5
COMPLETION PROCEDURES
stop the lift and/or a red LED indicator light
appears, remove the key to prevent further
use of the lift and immediately call the
manufacturer for assistance in diagnosing and
repairing the problem. DO NOT USE THE LIFT.
ADDITIONAL SYSTEM
CHECK
1.
After the successful testing of all safety
switches, secure the seat belt, sit on the lift
and operate to the top of the stairs. Keeping
the control switch pressed continuously, the
lift should gently decelerate and then stop at
the top of the rail.
2.
As a final adjustment, sit on the lift and do
two (2) complete up trips and stop with
the chair at the bottom. Then tighten the
compression screw in the top end plate, then
run the chair to the top and again tighten
the compression screw. Run the chair to
the middle and do a final tightening of the
compression screw.
3.
Drive the lift to the bottom, keeping the
control switch pressed all the time, and check
that the lift gently decelerates and stop so the
footrest pan is clear of the floor. If necessary
adjust the limit cams with a 5/64" Allen wrench.
4.
Move the lift about 3' from either the top
of bottom of the rail. After 30-seconds the
armrest LED indicator light will show orange
and beep indicating that the lift is not
positioned on a charge point. The beep will
stop after 30-seconds, but the armrest LED
indicator light will continue to flash orange.
5. Test the seat swivel at the top by using the levers
and swiveling the seat towards the landing and
stop the seat at 35 and 85 degrees. The seat
swivel levers will release into a locked position
at each of these angles. The lift will not operate
in any of these positions if the control switch is
depressed, and the LED indicator light will turn
SL600HD PINNACLE STAIR LIFT:
18
25MAR2022 | 75403 E
6. Drive to the top or bottom and check the battery
Install Manual
orange. Return the seat to its normal position and
the LED indicator light will turn green and the lift
will now operate normally.
charging light. If the light is orange or red, the
batteries are being charged.
Advertisement
Table of Contents
