3Gpp Standard Command And Operator Cloud Platform Standard Command; Power-On Process And Transparent Transmission Description - Ebyte EA01-S User Manual

Nb-iot module

Table of Contents

Chengdu Ebyte Electronic Technology Co., Ltd

AT command

AT+EIOT=<onoff>,<keysn>\r\n

AT+EIOT \r\n

<onoff>: 1 means open the Ebyte Cloud, 0 means close the Ebyte Cloud

<keysn>: The serial number key of Ebyte, that is, the SN of the module, it can be obtained with the command

AT+CGSN=0.

Note: Before using Ebyte Cloud, first use the command AT+PDUTYPE=3 to configure the data protocol type to Ebyte

Cloud.

4 3GPP standard command and operator cloud platform standard

command

Please refere to "EA01-S 3GPP and Operator Cloud Platform Standard command Manual"

First, the serial port reports "System power on mode:<mode>" to indicate the power-on mode of the module.

<mode>=0, means normal power-on mode;

<mode>=1, means that the reset pin hardware reset and power on;

<mode>=2, means software reset and power on;

<mode>=3, means RTC wakes up from deep sleep and power on;

<mode>=4, means the serial port RX pin wakes up from deep sleep and power on;

<mode>=5, means watchdog reset and power on.

Secondly, the serial port reports "TCPIP is OK" to indicate that the network is ready and the TCP/UDP link is ready.

Finally, the serial port reports "+XSSTATE:<id>,<state>" to indicate whether the TCP/UDP Socket is successfully

connected.

<id> means the created socket id, currently only supports 0 and 1, TCP/UDP channel can only use 0, COAP, MQTT,

Ebyte cloud can use 1.

<state> means the socket connection status, 1 means connected, 0 means disconnected.

Response

onoff: <onoff>,keysn: <keysn>

EA01-S User Manual

Table of Contents