Page 8
UART cable connected according to recommended circuit diagram,SIM card and antenna Connect the power supply, antenna, SIM card, serial cable and other hardware before testing. 1. Access the official website of EBYTE: www.ebyte.com, to download the latest GPRS/E840-TTL-4G02 series product configuration tool, install USB to 232/485 driver, run the software! 2.
Page 9
1. Click the tool "Enter Configuration Status" button and wait for the device parameters to be automatically obtained. After completion, the following figure is displayed:: 2. Query the signal strength, set the device connection server IP and port number to be: 116.62.42.192, 8124; (Ebyte test server), and finally click "Save all parameters", and finally as shown below::...
Page 10
3. Click the tool "Module Restart" button and wait for the device LINK light to be on. 4, Search "Ebyte IoT expert" WeChat public number, enter the page, click: Customer Support -> Device Test, the mobile phone screenshot interface is as follows:...
Page 12
+OK=E840-TTL(4G-02)_V1.0 Transmit : AT+SOCK2=1,TCPC,116.62.42.192,31687 //open SOCK2 and configure the network server parameters that SOCK2 will connect to (the parameter used here is Ebyte test server, not recommended for users) Transmit:AT+LINKSTA2 //read if SOCK2 has started connection with server +OK=Connect Transmit:AT+POTOCOL=ON // open protocol transmission mode Transmit:AT+POTOCOL...
8 Enable Ebyte IoT platform function The AT+EBTIOT command is used to set whether the module enables the transparent transmission function of the EBYTE cloud platform, after it is turned on, the information such as the heartbeat and registration packet configured by the user will be invalid.
Page 21
HEX) HEARTINFONEW HEARTM set/inquire heartbeat packet time SHORTM set/inquire short connection time EBTIOT set/inquire to enable Ebyte IoT Cloud Platform CREG Inquire if it is registered to network Inquire signal strength CPIN Inquire SIM card status POTOCOL set/inquire if protocol transmission mode starts set/inquire serial port parameter(9600,8,N,1)
Page 27
=<ctrl><CR> return:<CR><LF>+OK<CR><LF> parameter: ctrl EBYTE IoT function switch,0 off/1 on Note: After the IoT cloud function is enabled, the module is automatically connected to the Yiyi special IoT platform, ignoring the sock configuration, registration package, and heartbeat package function.AT+CSQ Function:...
Page 28
POTOCOL =<data><CR> return:<CR><LF>+OK<CR><LF> Parameters: data status Turns on the transmission of the EBYTE protocol Turns off the he transmission of the EBYTE protocol AT+ UARTEX(extending command) function: (AT+UART is for configuring baud rate and parity only) Set/inquire serial port parameter format:...
⚫ After the EBYTE cloud transparent transmission function is enabled, the high-speed mode is invalid. ⚫ When the device serial port outputs the words “pdp error, device will be reset!”, it indicates that the PDP context is disabled by the network.
Chengdu Ebyte Electronic Technology Co.,Ltd E840-TTL(4G-02)User Manual 5 Important Statement ⚫ All rights to interpret and modify this manual belong to Ebyte. ⚫ This manual will be updated based on the upgrade of firmware and hardware, please refer to the latest version. ⚫...