Table of Contents
Advertisement
10. Mounting Power Unit
A. Mount on the motor pump using 5/16" x 1-1/4" bolts and nylon nuts provided in the bolt box to Main
side column.
B. Connect the short hydraulic hose from T-Fitting to
the 90 degree fitting on side of valve block, as
circled in (Fig 10).
11. Latch-Release Cable Wiring & Accessories mounting
A. Mount the safety latch device & cable on each column, while ensure to route cable wire through tab
or handle, then secure with set-screw & clamp, as shown in (Fig. 11a & 11b).
Off Side Column
(Use Set Screw & Clamp to secure Cable Wiring to Safety Latches)
Fig. 11a
Main Side Column
19
TP12KSC-DX
July 2018-A
Fig. 10
Fig. 11b
Advertisement
Table of Contents
