Table of Contents
Advertisement
FOUNDATION and ANCHORING REQUIREMENTS
4-1/2"
Drill holes using 3/4"
carbide tipped
masonry drill bit per
ANSI standard
B94.12.1977
2.3 Tools & Equipment Required
• 12 quarts of Non-Detergent / Non-Foaming Hydraulic Oil - SAE-10, AW 32 or equivalent
• Chalk line and 12' Tape Measure
• Concrete hammer drill with 3/4" bit
• 11/16" open end wrench
• 3/4" open end wrench
• Torque wrench
• 15/16" deep socket or wrench
• 1-1/8" socket
• 13/16" open end wrench
• Level (18" minimum length)
• Vise grips
• Tape measure
• Funnel
• Hoist or Forklift (optional)
• Two 12' step ladders
• 1/4" drive ratchet with 5/16" socket
Clean hole.
Run nut down just
below impact section
of bolt. Drive anchor
into hole until nut and
washer contact base.
12
TP12KSC-DX
July 2018-A
3-1/2"
3-1/2"
4-1/2"
Tighten nut with
Torque wrench to
110 ft.-lbs.
Advertisement
Table of Contents
