Removing The Doors - Electrolux EI23BC35K Use & Care Manual

Getting through narrow spaces
If your refrigerator will not fit through an entrance area, you can reduce its size by removing the doors.
Check first by measuring the entrance.
Required Tools
You will need the following tools:
Top Hinge
Top Hinge
Cover Rear
Cover Front
Screw
Screw
Top
Hinge
Bottom
Screw
Hinge
Screw
To prepare for removing the doors:
1 Make sure the electrical power cord is unplugged from the wall outlet.
2 Open both doors and remove the toe grille (as explained in the
Installation Instructions that came with your appliance).
3 Remove any food from the door shelves.
4 Close the doors.
To remove the refrigerator top hinge cover:
1 Remove the three screws from each cover over the top door hinges.
2 Lift hinge cover straight up and off.
To remove the refrigerator door:
1 Trace lightly around the door's top hinge with a pencil. This makes
reinstallation easier.
2 Remove the two screws from the top hinge. Lift the door off of the
bottom hinge and set it aside.
3 Remove the two bottom hinge screws and hinge if necessary.
Adjustable Hinge
(some models)
To reinstall the refrigerator door, reverse the above steps.

Removing The Doors

Tools Necessary:
AND
Phillips Head ™
Non-Adjusting Hinge
(some models)
OR OR
Socket
Adjustable
Wrench Set
Wrench
CAUTION
Be sure doors are
set aside in a secure
position where they
cannot fall and cause
personal injury.
7
3/8" Fixed
Wrench