Removing The Doors - Electrolux ICON E23BC79SPS Use And Care Manual

Getting through narrow
spaces
If your refrigerator will not fit through an
entrance area, you can remove the doors.
Check first by measuring the entrance.
To prepare for removing the doors:
1 Make sure the electrical power cord
is unplugged from the wall outlet.
2 Open the freezer drawer and remove
the toe grille (see Installation section).
3 Remove any food from the door
shelves and close the doors.
To remove the top hinge covers:
1 Remove the two screws from each
cover over the top door hinges.
2 Lift inside edge of hinge cover and tilt
back.
Front
Cover Screw
Top Hinge
Cover
Hinge
Screws
Multi-wire
Cables
Leave
Hinge
With
Door
Left Door
Front
Rear
Cover Screw
Cover
Screw
Ground
Top
Screw
Hinge
Right Door

Removing the Doors

DO NOT remove the ground screw from
hinge.
To remove the refrigerator doors
Make sure the electrical power cord is
unplugged from the wall outlet.
1 Remove top hinge covers. Trace
Rear
Cover
Screw
Ground
Screw
Top
Hinge
2 Disconnect the harness by grasping
Water
Line
Top Hinge
Cover
Hinge
Screws
Leave
Hinge
With
Door
NOTE
WARNING
lightly around the door's top
hinges with a pencil. This makes
reinstallation easier.
both sides of the connector firmly,
depress the latch and pull apart.
11