Thermostat Installation Instructions; Manual Shut-Off Valve, Hose And Regulator Assembly Instructions - L.B. White AW250 Owner's Manual And Instructions

THERMOSTAT INSTALLATION
Electrical S S hock H H azard
Disconnect the electrical supply before connecting the
thermostat to the heater.
Failure to follow this warning can result in electrical
shock, leading to personal injury or death.
1. To C C onnect t t he S S eries T T ap P P lug T T hermostat K K it:
a. Connect the power cord of the heater to the
female side of the plug on the end of the
thermostat cord.
b. Plug the male side of the series tap plug on the
thermostat cord into a three-wire (grounded)
electrical outlet within the building.
MANUAL SHUT-OFF VALVE, HOSE
AND REGULATOR ASSEMBLY
1. Always use approved pipe thread compound suitable
for use with L.P. gas or natural gas on the threaded
connections.
2. Assemble the components together according to the
figure. This view is to show general assembly of the
components only. The regulator must always be
mounted so its vent, regardless of location on the
regulator, is always pointed downward.
3. Tighten all connections securely.
10
WARNING
2. To C C onnect t t he D D irect W W ired T T hermostat K K it t t o t t he
Control B B ox o o n t t he H H eater:
a. The installation and wiring of a thermostat must
be done by an electrician or someone properly
qualified.
b. The thermostat may use 18 gauge, 2 wire cord to
handle the low voltage being supplied to the
thermostat from the transformer.
c. Follow all instructions provided with the
thermostat kit.
d. The heater must be tested for proper operation
after the thermostat has been connected.
FIG. 5
REGULATOR VENT
TO CONTROL
VALVE INLET
REGULATOR
NIPPLE
VALVE, MANUAL
SHUT-OFF
GAS HOSE
ADAPTER
SEDIMENT TRAP