Partial Face Removal - Grizzly G0510ZW Owner's Manual

Always use cutterhead guard, and only
use a miter gauge to shape end of your
workpiece.
Figure 27. Anti-kickback Board Buddies in use.
(Guard removed for clarity—ALWAYS use the
guard!)
7.
To test your setup, run a scrap piece of stock
through shaper using your left hand to sup-
port workpiece against fence and your right
hand to feed, as shown in Figure 28. Switch
hands for clockwise rotation.
Figure 28. Feeding scrap piece into shaper to
test setup.
8. Confirm sample stock has been shaped
properly, make any final adjustments, and
run workpiece through shaper.
-26-

Partial Face Removal

To paritially remove stock face:
1.
DISCONNECT MACHINE FROM POWER!
2.
Adjust infeed fence to approximate desired
depth of cut, and lock infeed fence in place.
3.
Use straightedge to adjust outfeed fence to
same plane as infeed fence, and lock outfeed
fence in place.
4.
Set right and left wood faces to barely clear
cutter (see Figure 29). This allows maximum
support possible for workpiece while passing
cutter.
Note: Remember to tighten wood fence
faces before starting shaper.
Fence
Workpiece
Figure 29. Lateral fence alignment.
5.
Run a test piece through shaper.
Direction Of Feed
Figure 30. Partial feed fence adjustment.
Model G0510ZW (Mfd. Since 9/16)