Advertisement
S T E P
4
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Wrench tighten ALL hardware at the end of STEP 4D. Some components may be
pre-assembled. Nylon lock nuts will not fully screw onto bolts, they must be wrench
tighten to fully go on.
4A. Attach Stability Ball Holders (L) to the left side of Lower &
Upper Uprights (D & E) using:
6 - (#5) M10x60mm Hex Head Bolt
12 - (#9) M10 Flat Washer
6 - (#11) M10 Nylon Lock Nut
4B. Attach Accessory Hanger (J) to Top Medicine Ball Tray (G) using:
4 - (#7) M8x55mm Hex Head Bolt
8 - (#10) M8 Flat Washer
4 - (#12) M8 Nylon Lock Nut
4C. Attach Mat Hanger (M) to right side of Upper Upright (E) using:
2 - (#5) M10x60mm Hex Head Bolt
4 - (#9) M10 Flat Washer
2 - (#11) M10 Nylon Lock Nut
4D. Attach Hook (K) to right side of Upper Upright (E) using:
2 - (#3) M10x100mm Hex Head Bolt
4 - (#9) M10 Flat Washer
2 - (#11) M10 Nylon Lock Nut
16
Advertisement
