Body Solid GAR250 Assembly Instructions & Owner's Manual page 14

S T E P
3
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Wrench tighten ALL hardware at the end of STEP 3D. Some components may be
pre-assembled. Nylon lock nuts will not fully screw onto bolts, they must be wrench
tighten to fully go on.
3A. Attach Upper Uprights (E) to Lower Upright (D) using:
4 - (#4) M10x95mm Hex Head Bolt
8 - (#9) M10 Flat Washer
4 - (#11) M10 Nylon Lock Nut
3B. Attach Medicine Ball Tray (F) to Upper Uprights (D) using:
4 - (#5) M10x60mm Hex Head Bolt
8 - (#9) M10 Flat Washer
4 - (#11) M10 Nylon Lock Nut
3C. Attach Top Medicine Ball Tray (G) to Upper Uprights (D) using:
4 - (#5) M10x60mm Hex Head Bolt
8 - (#9) M10 Flat Washer
4 - (#11) M10 Nylon Lock Nut
3D. Attach Logo Plate (H) to Upper Uprights (D) using:
4 - (#5) M10x60mm Hex Head Bolt
8 - (#9) M10 Flat Washer
4 - (#11) M10 Nylon Lock Nut
14