Advertisement
S T E P
2
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. DO NOT wrench tighten until instructed.
Some components may be pre-assembled. Nylon lock nuts will not fully screw onto
bolts, they must be wrench tightened to fully go on.
2A. Attach Upper Tray (C) to Lower Upright (D) using:
8 - (#5) M10x60mm Hex Head Bolt
16 - (#9) M10 Flat Washer
8 - (#11) M10 Nylon Lock Nut
2B. Attach Medicine Ball Tray (F) to Lower Upright (D) using:
8 - (#5) M10x60mm Hex Head Bolt
16 - (#9) M10 Flat Washer
8 - (#11) M10 Nylon Lock Nut
12
Advertisement
