ETC Echo Echoflex Interface How To Configure page 2

Hide thumbs Also See for Echo Echoflex Interface:

c. Use appropriate TEACH option on Echoflex input device to link

d. Repeat for other inputs or learn mode on EEI will expire after 30 seconds of inactivity

2. Link outputs (teach EEI to Echoflex output devices [controllers])

a. Tap 'SELECT' button to choose desired output

b. Put Echoflex output device into learn mode

c. Tap 'LEARN/TEACH' button on EEI to teach/link to the device

d. Repeat for other outputs or learn mode on output device will expire after 30 seconds of inactivity

3. Clear all links for an input/output

a. Tap 'SELECT' button to choose desired input/output

b. Press and hold 'CLEAR' button for 5 seconds

Manual Control (make sure the EEI can communicate to both sides)

1. Of wireless inputs

a. Tap 'SELECT' button to choose desired input

b. Use 'ON' and 'OFF' buttons to simulate on event action and off event action

I. Ex A: If echoflex switch station linked to the input, single tap plays programmed preset or space off,

while pressing and holding performs space raise or lower

II. See install guide for full list of actions

2. Of wireless outputs

Tap 'SELECT' button to choose desired output

b. Use 'ON' and 'OFF' buttons to increase/decrease the linked output device's level

I. Single tap sets output to 100% or 0% over 2 seconds

II. Pressing and holding raises or lowers output level

III. Double tap sets output to 100% or 0% over 500 ms

Re-record Echo Presets

https://support.etcconnect.com/ETC/Architectural/Aero_and_EchoFlex/Aero_and_Echoflex_Gateways_and_Interfaces/How_...

Updated: Fri, 17 Sep 2021 16:17:12 GMT