At+Qisendex Send Hex String Data - Quectel BG96 TCP/IP Application Note

<read_actual_length>
<remoteIP>
<remote_port>
<data>
<total_receive_length>
<have_read_length>
<unread_length>

2.2.9. AT+QISENDEX Send Hex String Data

The Write Command sends hex string data and cannot be applied for "UDP SERVICE" and "TCP
LISTENER" sockets.
AT+QISENDEX Send Hex String Data
Test Command
AT+QISENDEX=?
Write Command
AT+QISENDEX=<connectID>,<h
ex_string>
Maximum Response Time
Characteristics
Parameter
<connectID> Integer type. Socket service index. Range: 0–11.
<hex_string> String type. Hex string data. The maximum length is 512 bytes.
BG96_TCP/IP_Application_Note
Default value: 1500. Unit: byte.
Integer type. Length of the data that has been actually retrieved. Unit: byte.
String type. Remote IP address. It is only valid when <service_type> is "UDP
SERVICE".
Integer type. Remote port. It is only valid when <service_type> is "UDP
SERVICE".
String type. Retrieved data.
Integer type. Total length of received data. Unit: byte.
Integer type. Length of the data that has been retrieved. Unit: byte.
Integer type. Length of the data that has not been retrieved. Unit: byte.
Response
+QISENDEX: (range of supported <connectID>s),<hex_string>
OK
Response
If the hex string data is sent successfully:
SEND OK
If the sending buffer is full:
SEND FAIL
If the connection does not exist:
ERROR
120 s, determined by network.
/
LPWA Module Series
BG96 TCP/IP Application Note
22 / 52