Edirol LVS-400 Supplementary Manual page 9

3
While continuing to hold down the BUS button, turn the EFFECTS LEVEL knob
or TRANSITION TIME knob.
You can move the insert image vertically with the EFFECTS LEVEL knob and
horizontally with the TRANSITION TIME knob.
A-BUS
3
B-BUS
4
When you are finished adjusting the position, release the BUS button.
Changing the Size of the Insert Image
You can change the size of the insert image displayed in PinP.
1
Select the PinP pattern you want to use with the MODE knob.
2
Hold down [EFFECTS] for at least three seconds.
3
While continuing to hold down [EFFECTS], turn the TRANSITION TIME knob.
You can change the insert image size with the TRANSITION TIME knob.
B-BUS
4
When you are finished adjusting the position, release [EFFECTS].
A / B MODE
EFFECTS
3
MODE LEVEL
TRANSITION TRANSITION TIME
3
MIX WIPE EFFECTS
MODE LEVEL
TRANSITION TRANSITION TIME
3
MIX WIPE EFFECTS
3
About the New Functions
A-BUS
B-BUS
B-BUS
You can set the size separately
for each of the four corners and
the center position.
Size changes remain in effect
until the power is turned off.
Turning off the power restores
the size to the original factory
default settings.
The functions for adjusting the
insert image position and
changing the size of the image
are enabled in Normal mode
(not A/B mode).
9