Edirol LVS-400 Supplementary Manual page 8

About the New Functions
Relationship Between the Main and Insert Images in PinP
The relationship between the image occupying the entire screen (the main
image) and the smaller image within that (the insert image) is determined by the
position of the video fader.
1. Tilt the video fader to the bus carrying the image you want to use as the
main image.
The image corresponding to the lit (selected) BUS button is output from the
OUTPUT connector.
A
Main image
B
Insert image
2. Press [EFFECTS].
The EFFECTS button will lit. The image on the side to which the video fader is
tilted is the main image (with the BUS button lit), and the image on the opposite
bus is used as the insert image (with the BUS button flashing)
3. Select the PinP pattern you want to use with the MODE knob.
4. Tilt the video fader towards the small (foreground) image side.
The composite output video contains the image corresponding to the flashing
BUS button and the image corresponding to the lit BUS button.
Lit
Changing the Position of the Insert Image
You can change the position of the insert image displayed in PinP.
1
Select the PinP pattern you want to use with the MODE knob.
2
Hold down the flashing BUS button ([1]–[4]) for at least three seconds.
A-BUS
2
B-BUS
8
A-BUS
A
Output
B-BUS
A
Main image
B
Insert image
Flash
EFFECTS
MODE
TRANSITION TRANSITION TIME
A-BUS
A
B
Output
B-BUS
A / B MODE
A-BUS
LEVEL
When [EFFECTS] is already lit
prior to Step 2, press [MIX] or
[WIPE] so that [EFFECTS] light
goes off. This is because the
main and insert images are
determined the instant
[EFFECTS] is pressed and its
light goes on.