Edirol LVS-400 Supplementary Manual page 14

About the New Functions
Blacking out the output image
Here's how you can temporarily black out the output image.
1
Press [OUTPUT ON/OFF].
When you press the LVS-400's [OUTPUT ON/OFF], the button flashes, and the output
from the OUTPUT connector turns black. The image is output when the button is
pressed again.
Adjusting the Time for the Image to Fade to Black
You can have the image output from the OUTPUT connector gradually fade out
to black over a preset length of time.
1. Connect a monitor display to the MONITOR OUT connector.
2. Hold down [OUTPUT ON/OFF] for at least three seconds.
"Time = *" ("*" indicates a number of 0–9) appears in the monitor display
connected to the MONITOR OUT connector.
3. While continuing to hold down [OUTPUT ON/OFF], turn the TRANSITION
TIME knob.
The transition time lengthens as the value is increased.
4. When you are finished adjusting the position, release [EFFECTS].
A
A
14
A
TRANSITION
TIME
Time changes remain in effect
until the power is turned off.
Turning off the power restores
the time to the original factory
default settings (TIME=3).
The OUTPUT ON/OFF button
flash during transitions and
switching.