Edirol LVS-400 Supplementary Manual page 10

About the New Functions
Creating Composite Video with the A-BUS Image in
the White or Black Portions of the B-BUS Image
1
Tilt the video fader towards the A-BUS side.
The image corresponding to the lit (selected) A-BUS button is output from the
OUTPUT connector.
2
Press [EFFECTS].
The B-BUS button will flash. The image corresponding to the flashing (selected) button
becomes the key image (the image portions of which are to be removed).
3
Turn the MODE knob to "WHT" or "BLK" – depending on portion to eliminate.
The LVS-400 switches to White or Black Luminance Key mode.
A-BUS
B-BUS
4
Tilt the video fader towards the B-BUS side.
Light portions of the image corresponding to the flashing B-BUS button are replaced
with the A-BUS image.
5
Turn the EFFECTS LEVEL knob.
Adjust the sensitivity so that the results correspond to the light or dark portions of the
B-BUS image.
A-BUS
B-BUS
10
EFFECTS
3
MODE LEVEL
TRANSITION TRANSITION TIME
MIX WIPE EFFECTS
2
EFFECTS
5
MODE LEVEL
TRANSITION TRANSITION TIME
MIX WIPE EFFECTS
A / B MODE
A-BUS
1
B-BUS
A / B MODE
A-BUS
4
B-BUS
To create composite video with
the specific color replaced,
turn the MODE knob to
"CHR."
Pressing the A-BUS or B-BUS
buttons to switch images while
creating a composite using two
images with the EFFECT
MODE knob set to "WHT,"
"BLK," or "CHR" may cause
the image to become
disrupted.