Table of Contents
Advertisement
Timed operation:
• Enter the target time in minutes with the control buttons
(+ and -).
- Press and hold the two-hand switch for 3 seconds.
- The rest of the process takes place automatically.
The time set in the display will count downwards.
- After the time has elapsed, the lifting carriage moves
upwards, back to the starting position.
- The same process is repeated by pressing the two-hand
switch once again.
• Pressing a two-hand switch button one time will abort
the time program.
– The lifting carriage moves upwards, back to
the starting position.
Continuous operation:
• Set by pressing the control key "Continuous operation"
- The operation can be terminated at any time by pressing
a button on the two-hand switch.
Note
• While switched off , the lifting device can remain connected to mains power.
It can be disconnected by pulling the mains plug.
3.3
Additional settings
By pressing the "Settings" button, it is possible to set another
language or to call up the operating hours display.
Settings currently possible: German, English, French
The oscillation can be switched on or off in the display.
• When oscillation is active, the lifting device moves downward
after the lowering, and then oscillates in the ultrasonic or
rinsing bath for the duration of the operating time.
• If the oscillation is switched off , the lifting device moves only
to the bottom position after the lowering, and moves up again
after the time has elapsed.
23626-002 GB/2021-10
1 electronic GmbH & Co. KG • Heinrichstraße 3-4 • 12207 Berlin • Deutschland • info@bandelin.com
15 / 24
Advertisement
Table of Contents
