Zaxnet Receive Before Transmit Time; Record Beep Set - Zaxcom ZMT270 User Manual

Zaxcom ZMT3-HH

ZaxNet Receive Before Transmit Time

RX TO TX TIME:
OFF (NORMAL RX)
ZAXNET RX TO TX:
0 SEC: TX ONLY
ZAXNET RX TO TX:
20 SEC
This menu adjusts the state of the ZaxNet transceiver. This also sets how long after boot-up up the TRXLT3
will search for ZaxNet time code before it begins transmitting its audio over ZaxNet for monitoring
purposes. This is so the ZMT3-HH can lock to ZaxNet time code source before the unit will send confidence
audio over ZaxNet.

Record Beep Set

This menu will only appear if the ZMT3-HH is set to transmit (TX) mode
ZNET RECORD BEEP
OFF
When the record beep is set to ON, and the ZMT3-HH is recording, the confidence audio sent to the ERX via
ZaxNet will have an audible beep, in variable intervals, giving conformation that the ZMT3-HH is indeed
recording. The beeps will only be heard in the ERX and will not be recorded on the card, or be sent to the UHF
receiver. The intervals can be set between 2 to 18 seconds in 2 second increments.
Receive only mode.
The ZaxNet transceiver will only receive ZaxNet and NOT go into
transmit mode. Therefore no ZaxNet TC and/or audio will be
transmitted. This setting shuts off the ZaxNet transmitter.
Transmit only mode.
The ZaxNet transceiver will only transmit ZaxNet TC and
audio and will NOT receive wireless TC or ZaxNet
commands. This setting shuts off the ZaxNet receiver.
Receive then Transmit mode.
After boot up the ZaxNet transceiver will search for a
ZaxNet signal for the selected time so it can receive and
lock time code before it begins to transmit TC and
confidence audio.
This is adjustable from 1 to 20 Seconds.
14
ZaxNet Menu