Zaxnet Receive Before Transmit Time - Zaxcom ZMT-267 User Manual

Table of Contents

Zaxcom ZMT3 Phantom 2

ZaxNet Receive Before Transmit Time

RX TO TX TIME:

OFF (NORMAL RX)

ZAXNET RX TO TX:

0 SEC: TX ONLY

ZAXNET RX TO TX:

20 SEC

This menu adjusts the state of the ZaxNet transceiver. This also sets how long after boot-up up the ZMT3

Phantom 2 will search for ZaxNet time code before it begins transmitting its audio over ZaxNet for

monitoring purposes. This is so the ZMT3 Phantom 2 can lock to ZaxNet time code source before the unit

will send confidence audio over ZaxNet.

Receive only mode.

The ZaxNet transceiver will only receive ZaxNet and NOT go into

transmit mode. Therefore no ZaxNet TC and/or audio will be

transmitted. This setting shuts off the ZaxNet transmitter.

Transmit only mode.

The ZaxNet transceiver will only transmit ZaxNet TC and

audio and will NOT receive wireless TC or ZaxNet

commands. This setting shuts off the ZaxNet receiver.

Receive then Transmit mode.

After boot up the ZaxNet transceiver will search for a

ZaxNet signal for the selected time so it can receive and

lock time code before it begins to transmit TC and

confidence audio.

ZaxNet Menu

Table of Contents

Do you have a question about the ZMT-267 and is the answer not in the manual?

Zmt3 phantom 2