Table of Contents
Advertisement
Zaxcom ZMT4 Flex
ZaxNet Receive Before Transmit Time
RX TO TX TIME:
OFF (NORMAL RX)
ZAXNET RX TO TX:
0 SEC: TX ONLY
ZAXNET RX TO TX:
20 SEC
This menu adjusts the state of the ZaxNet transceiver. This also sets how long after boot-up up the ZMT4
Flex will search for ZaxNet time code before it begins transmitting its audio over ZaxNet for monitoring
purposes. This is so the ZMT4 Flex can lock to ZaxNet time code source before the unit will send confidence
audio over ZaxNet.
Receive only mode.
The ZaxNet transceiver will only receive ZaxNet and NOT go into
transmit mode. Therefore, no ZaxNet TC and/or audio will be
transmitted. This setting shuts off the ZaxNet transmitter.
Transmit only mode.
The ZaxNet transceiver will only transmit ZaxNet TC and
audio and will NOT receive wireless TC or ZaxNet
commands. This setting shuts off the ZaxNet receiver.
Receive then Transmit mode.
After booting up the ZaxNet transceiver will search for a
ZaxNet signal for the selected time so it can receive and
lock time code before it begins to transmit TC and
confidence audio.
15
ZaxNet Menu
Advertisement
Table of Contents
Need help?
Do you have a question about the ZMT-421 and is the answer not in the manual?
Questions and answers