Maintenance Alerts - Honeywell PD45 User Manual

Maintenance Alerts

To view these settings:
•
•
Maintenance
Alerts Setting
Odometer (User
Resettable)
Odometer (Printer)
Odometer (Printhead)
Replace Printhead
Clean Printhead
Faulty Dot
Ribbon Low Diameter
PD45 User Guide
From the printer Main Menu, select Settings > System Settings > Maintenance
Alerts.
From the printer web page, click the Configure tab. Go to System Settings >
Maintenance Alerts.
Description
Sets the length of media (in meters) that the printer prints
before the Odometer (User Resettable) alert is sent, if this
alert is configured. Unit of measurement is defined in the Unit
of Measure parameter. Range is 0 to 4294967295.
Sets the length of media (in meters) that the printer prints
before the Odometer (Printer) alert is sent. Unit of
measurement is defined in the Unit of Measure parameter.
Range is 0 to 4294967295.
Sets the length of media (in meters) that the printer prints
before the Odometer (Current Printhead) alert is sent, if this
alert is configured. Unit of measurement is defined in the Unit
of Measure parameter. Range is 0 to 4294967295.
Sets the length of media (in meters) that the printer prints
before the Replace Printhead alert is sent, if this alert is
configured. Unit of measurement is defined in the Unit of
Measure parameter. Range is 0 to 4294967295.
Sets the length of media (in meters) that the printer prints
before the Clean Printhead alert is sent, if this alert is
configured. Unit of measurement is defined in the Unit of
Measure parameter. Range is 0 to 4294967295.
Sets the number of faulty dots on the printhead before the
Faulty Dot alert is sent, if this alert is configured. Range is
0 to 4294967295.
Sets the minimum diameter of the ribbon roll before the
Ribbon Low alert is sent, if this alert is configured. Range is 0
to 200 mm.
Default
0
0
0
0
0
0
0
77