Ghost Controls Ghost Pro Series Installation And Owner's Manual page 4

L D M 2 D U A L K I T
4
BEFORE YOU BEGIN:
■ This dual opener is for a gate opening of no more the 24 feet wide.
■ A 12 volt automotive/marine battery or Ghost Controls ABBT2 Battery Box Kit is required to power the operator.
■ Push-To-Open applications (gate that swings away from the property) will require the Ghost Controls push-to-open
bracket kit (AXPO).
■ If charging your system with the AC transformer, you will need to purchase a 16 gauge stranded low voltage wire to
connect the transformer to the gate operator control board. Up to 1,000 ft. of wire can be used.
■ For installations farther than 1,000 ft. from an AC power source, the Ghost Controls 10 Watt Solar Panel Kit (AXDP) or
30 Watt Solar Panel kit (AX30) can be used to charge the battery. Up to 30 Watts of solar power can be used.
CUSTOMIZING YOUR GATE:
Information on additional accessories shown below can be found on the accessory page 65 or visit
www.ghostcontrols.com
INCLUDED IN LSM1 and LSM2 KITS
ADDITIONAL ACCESSORIES
12V battery required NOT included
Opens gates up to 20 ft. or 1,000 lbs.
per gate leaf
Wireless
Keypad (AXWK)
used for exit
of property
5 Button 3 Button
Transmitter Transmitter
(AXP1) (AXS1)
© G h o s t C o n t r o l s
®
Safety Placards
Water Resistant
Transmitter
(AXR1)
2 0 2 0
LSM1
Operator Arm
Low Voltage Wire
(AXLV)
Wireless Vehicle Sensor
(AXWV)