Moons' SRAC2 Quick Setup Manual

Moons' SRAC2 Quick Setup Manual

Ac input step motor drive
Hide thumbs Also See for SRAC2:

Advertisement

SRAC2
AC Input Step Motor Drive
1

Requirements

To use the SRAC2 Step Drive, the following items
are needed:
• Universal AC input of 80 to 265 VAC
• AC input voltage must be selected by switch
• Pulse & Direction signal
• A compatible step motor

Connecting to a Motor

Connect the drive to the motor. Four lead
motors can be connected
in only one way. If using a
non MOONS' motor,
consult the motor specs
for wiring information.

Selecting the Motor

Each position of the 16-bit rotary selects a different motor, automatically setting the configuration parameters
in the drive. The SRAC2 drive comes programmed with up to 16 typical motors as factory
defaults. Drives can be customized with specially selected motors when required. Available
options are listed on the drive label. Each motor in the loaded database has unique settings to
optimize the anti-resonance.
If the motor selection is changed, the drive power supply will need to be cycled.
LED
Motor Selection Switch
OUT-
OUT+
EN-
EN+
I/O Connector
DIR-
DIR+
STEP-
STEP+
SW12
SW11
SW10
SW9
Selection Switch
SW8
SW7
SW6
SW5
SW4
SW3
SW2
SW1
B-
B+
Motor Connector
A-
A+
N
Power Connector
L
3
White
Green
8 LEAD
MOTOR
Brown
C
Yellow
Blue
Gray
Pink
8-Lead Parallel Connected
4
Quick Set-Up Guide
Connect to Power
Use the supplied connector to connect to the AC
supply according to the diagram below. Use 16
AWG wire for Line (L) and Neutral (N). Use 14 AWG
for Earth Ground (G).
AC input voltage must be selected by switch.
Check input voltage avoiding damage before
power on!
80VAC<Input AC Voltage<135VAC:
set the switch on 115V Status
135VAC<Input AC Voltage<265VAC:
set the switch on 230V Status
The SRAC2 has an internal 5A fast acting fuse.
Care should be taken when working with high voltages.
Black A+
4 LEAD
MOTOR
Green A-
Red B+
Blue B-
4-Lead Biploar Motor
White A
8 LEAD
Brown
MOTOR
Green
Yellow C
Gray B
Pink
Red
Blue
Red D
D
8-Lead Series Connected
2
Neutral (white)
Line-hot (black)
Earth Ground (green)
Black A+
6 LEAD
MOTOR
Yellow A-
Green NC
B+
B-
Red
White
6-Lead Center Tap Connected
Black A+
6 LEAD
MOTOR
Yellow NC
Green A-
B+
NC
Red
White
6-Lead Series Connected
NC
Blue
B-
Blue

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SRAC2 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Moons' SRAC2

  • Page 1 Each position of the 16-bit rotary selects a different motor, automatically setting the configuration parameters in the drive. The SRAC2 drive comes programmed with up to 16 typical motors as factory defaults. Drives can be customized with specially selected motors when required. Available options are listed on the drive label.
  • Page 2 Selection Switches Many operational parameters of the Idle Current Microstepping Running Current SRAC2 can be set or changed by position SW10 SW11 SW12 switches - either by a single switch or a Anti Resonance Self Test combination of ON/OFF settings of 2 or more...

Table of Contents