EchoStar DSB-808 2Ci User Manual page 29

EchoNAV User Interface
NOTE
You only need to add a satellite and/or transponder if it is not available from the internal
database. When you add a satellite, you have to identify at least one transponder.
You only need to change PIDs when your service provider changes these.
A digital signal is basically broken up in Video and Audio information which are
synchronized with the PCR PID.
I
F YOU WANT TO ADD A NEW
:
SATELLITE
1. Press the MENU key and
select the Installation
setup - System setup.
2. Read the help text.
3. Select SAT: S00.
4. Press the OK key to open
the Add data menu.
5. In the SAT option, press
the OK key.
6. Rename the SAT.
7. Set the orbital position:
Degrees and Location.
8. Set the first transponder:
Frequency, Polarity and
Symbol rate.
9. Leave the PID setting as
Auto.
10. Make sure that the signal
indicator shows a reading.
11. If you want to add another
TP, select Add more.
12. If you want to search
channels, select
Continue.
13. Press the OK key to start
Search channels.
EchoNAV Version 2.2
I
F YOU WANT TO ADD A
:
TRANSPONDER
1. Press the MENU key and
select the Installation
setup - System setup.
2. Read the help text.
3. For DiSEqC1.2:
a. Select TP: TP00.
2. For Fixed:
a. Select Check signal.
b. Select TP: TP00.
3. Set the new transponder:
Frequency, Polarity and
Symbol rate.
4. Leave the PID setting as
Auto.
5. Make sure, the signal
indicator shows a reading.
6. If you want to add another
TP, select Add more.
7. If you want to search
channels, select
Continue.
8. Press the OK key to start
Search channels.
Section 3
I PID:
F YOU WANT TO EDIT A
1. Press the OK key and
Select Edit: Edit PID.
2. Read the help text.
3. The channel list (grouped
Per TP) shows.
4. Make a selection and
press the OK key.
5. The Edit PID menu
shows. Note that the
transparent areas show
additional information.
6. Select and set the
required PID.
7. Save settings.
8. Press the White key to
exit the Edit PID option.
Page 3 - 5
English
3