Table of Contents
Advertisement
Familiarization
Section 2
I
I
-
User LNB setting (Advanced only)
English
2
I
I
I
I
I
I
I
I
I
I
2.3.
CONDITIONAL ACCESS
NOTE
The information pages can show differently for the modules and smartcards that you
use. EchoStar has no control over the information as provided by the service provider,
therefore no specific information is given.
-
Common interface1
I
,
-
Common interface2
I
-
Embedded smartcard reader
I
Page 2 - 8
Fine tune
To move the dish for best signal level and quality. The signal
indicator helps you to check the signal quality (top) and strength
(bottom) for the defined SAT and Network.
Search channels will bring you to the next menu to start the
channel search.
Search channels
Search channels does a channel search on the defined SAT.
User LNB
To select the User LNB that you want to define.
LO low
To select the Low Band Local oscillator frequency.
LO high
To select the High Band Local oscillator frequency.
DiSEqC
To select the DiSEqC switch.
Port
To select the DiSEqC Port to which the LNB is connected.
Polarity control
To select the device that is used to control the Horizontal and
Vertical Polarity.
Band control
To select the device that is used to switch between the High and
Low Band.
C/Ku control
To select the device that is used to switch between the C and
Ku Band.
0/22kHz control
To switch the 0/22kHz to On or Off.
Save settings
To save the changes and return to the Program satellites menu.
Module1
To access the Module1 information pages to set and view the
options for the inserted Module1 and Smartcard.
Module2
To access the Module2 information pages to set and view the
options for the inserted Module1 and Smartcard.
Smartcard
To access the Embedded smartcard reader pages to set and
view the options for the inserted Smartcard.
EchoNAV User Interface
Digital Satellite Receivers - Fixed
Advertisement
Table of Contents
