Table of Contents
Advertisement
EchoNAV User Interface
3.3. THE ADVANCED SETUP MENU-STRUCTURE
The EchoNAV User Interface makes use of the MENU, OK and arrow keys on your Remote
Control Unit (RCU) to navigate through the Installation setup menu which gives you access to
the sub-menus. Each sub-menu allows you to customize the settings to match your
installation. Note that the menu contains dynamic pages which means that options are or are
not available depending on the selections you make. When the Advanced setup menu
shows, you can customize:
System setup
Program satellites
Search channels
Local time
3.4. DEFINE THE INSTALLATION SETUP - ADVANCED
1. Define the System setup.
2. Read the help text.
3. Select the Advanced
mode.
4. Select Program satellites.
5. Press the OK key.
6. Program satellites.
7. Select the SAT.
EchoNAV Version 2.2
I
To set the installation type you use.
I
To select the Easy or Advanced installation mode.
I
To set the User LNB you have installed.
I
To set the switch that controls the installation (if used).
I
To define the satellite you want to scan for the LNB.
I
To define the User LNB you have installed.
I
To define a transponder of the selected satellite.
I
To move the dish for best signal level and quality.
I
Wait for the search to complete.
I
To set the current date.
I
To set the current time.
8. Select the User LNB.
9. Press the i-key.
10. User LNB setting
11. Define the User LNB.
12. Select Save settings.
13. Press the OK key.
14. Select Search channels.
15. Search channels.
Initial Installation
16. Wait for the search to
complete.
17. Press the OK key.
18. Local time.
19. Select the Local time.
20. Select Save settings.
21. Select Continue.
22. Press the OK key.
Section 1
English
1
Page 1 - 5
Advertisement
Table of Contents
