EchoStar DSB-808 2Ci User Manual page 18

Familiarization
Section 2
- Fixed dish setup (DiSEqC1.2 only)
NOTE
In a DiSEqC1.2 installation (System - DiSEqC1.2), it is possible to add one or more
fixed dishes with the help of an external switch.
I
English
I
2
I
I
I
I
I
- Program satellites (DiSEqC1.2 only)
I
I
I
I
I
I
I
I
- About EchoStar
I
I
I
I
I
Page 2 - 6
LNBs To set the number of LNBs you use. You only can change the
setting if you have selected a Switch in the System setup.
Polarity To set the device that controls the Polarity (not used).
Switch Shows the Switch that you have selected in the System setup.
LNB1 Shows the LNB1 that you have selected in the System setup.
LNB2, 3, 4 Select for every LNB, a pre-defined LNBs, the related SAT and
Port.
Check signal Check signal verifies the settings you made before. If the
settings are correct, the TP indicator becomes green. If the
indicator becomes red, select another TP or make sure you
have selected the correct Port for this SAT.
If your TP is not listed, select TP00 which brings you to the Add
data menu.
The signal indicator helps you to check the signal quality (top)
and strength (bottom) for the defined SAT and Network.
Search channels will bring you to the next menu to start the
channel search.
Search channels Search channels does a channel search on the defined SAT.
SAT To define the satellite you want to search channels on.
If your SAT is not listed, select S00 which brings you to the Add
data menu.
Longitude Shows the orbital position of the defined SAT.
User LNB Shows the LNB that you have selected in the System setup.
TP Shows a transponder, from the internal database, of the defined
SAT. If the signal indicator shows low levels, select another TP
that gives a better signal. If your TP is not listed, select TP00
which brings you to the Add data menu.
Skew (not used).
Position To move the dish and find the defined SAT.
Fine tune To move the dish for best signal level and quality. The signal
indicator helps you to check the signal quality (top) and strength
(bottom) for the defined SAT and Network.
Search channels will bring you to the next menu to start the
channel search.
Search channels Search channels does a channel search on the defined SAT.
Company Shows the Company name.
Address Shows the visit address of EchoStar.
EchoNAV Shows the current EchoNAV software version.
Boot version Shows the current Boot version.
Internet site Shows the EchoStar Internet site.
EchoNAV User Interface
Digital Satellite Receivers - Fixed