Software-Dependent Functions; Reset After Power On; Low Speed Area; Auto Move - LOGICDATA LogicS-2 User Manual

User Manual
LogicS-2 / LogicS-3

4.3 Software-dependent Functions

Note: Prior to delivery, the LogicS control box is being parameterized.
Following functions are only available if the control box is
parameterized accordingly.

4.3.1. Reset after Power On

After each power-on (e.g. connecting the power cord) following reset
procedure is carried out:
1. The desk up key is locked (this key has no function at this
moment)
2. When pressing desk down, the desk moves to the lower end
position at half speed.
3. Now, the control box is ready for normal operation.

4.3.2. Low Speed Area

This function automatically decreases the driving speed of the desk before
reaching one of the following positions:
• Upper and lower end position
• Any saved position

4.3.3. Auto Move

From an ergonomical point of view it is reasonable to regularly change the
desk-height. The auto move function reminds the user to change the height of
the desk. This is done by a short Up-Down movement of the desk.
Note: The time interval of this "reminder funtion" is software-
configurable.

4.3.4. Flexible Desk Positions

This function is an additional ergonomic measure. The saved desk positions
get varied randomly to a certain degree.
This function is available for:
• Last upper and lower position
• Any saved position
Page 22/33