Every 400 Hours; Adjusting Front Axle Pivot; Changing Transmission Fluid - Kubota BX25DLB Operator's Manual

EVERY 400 HOURS

BAdjusting Front Axle Pivot
If the front axle pivot pin adjustment is not correct, front
wheel vibration can occur causing vibration in the steering
wheel.
C Adjusting procedure
Remove the split pin, tighten the adjusting nut (tightening
torque 20 N-m, 2.0 kgf-m, 15 lbf-ft), then make sure that
one of the nut slots aligns with the split pin hole, tighten
the nut slightly if necessary to align. Replace the split pin.
(1) Adjusting nut
(2) Split pin
BChanging Transmission Fluid
To avoid personal injury:
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. To drain the used oil, remove the drain plug at the
bottom of the transmission case and drain the oil
completely into the oil pan.
2. After draining reinstall the drain plug.
3. Clean the transmission strainer.
4. Fill with new KUBOTA SUPER UDT fluid up to the
upper notch on the dipstick.
(See "LUBRICANTS" in "MAINTENANCE OF THE
TRACTOR" section
"PERIODIC SERVICE OF THE TRACTOR" section.)
5. After running the engine for a few minutes, stop it and
check the oil level again, add oil to prescribed level.
6. Properly dispose of used oil.
Oil capacity 11.6 L (3.1 U.S. gals.)
and "DAILY CHECK"
PERIODIC SERVICE OF THE TRACTOR
(1) Drain plug
(1) Oil inlet
(2) Dipstick
A Do not operate the tractor immediately after changing
the transmission fluid.
Run the engine at medium speed for a few minutes to
prevent damage to the transmission.
in
(A) Oil level is acceptable within
this range.
89