Kubota BX25DLB Operator's Manual page 91

4. Raise the boom of the loader until the pin at the upper
bosses of the attachment seat in the Quick Coupler
receivers, and the rear of the attachment is raised
slightly off the ground.
(1) Pin 3
To avoid personal injury:
A Do not raise attachment completely off the
ground at this point. the attachment could
swing off the quick coupler.
5. Keeping the attachment at ground level, move the
loader control lever to the "roll back" position until the
cylinders stop. Turn off the engine and set the parking
brake.
(U) "UP" position
OPERATING THE LOADER
6. Install both Hitch Pins and Snapper Pins as shown in
the following illustration.
The illustration shows a properly attached bucket.
To avoid personal injury:
A Make sure both hitch pins and snapper pins are
properly installed before moving or operating
attachments.
A Keep hitch pins and snapper pins assembled in
the BX6315 quick coupler at all times, even if no
attachment is being used.
A Replace any pins or other parts which are lost
or broken.
7. You are now ready to use the attached attachment.
Compatible attachments can be attached and
detached using the same method.
To avoid personal injury:
A Never operate or transport attachments which
are not attached completely.
A Always replace
immediately.
(A) Hitch Pins
(B) Snapper Pins
damaged hardware
63