Table of Contents
Advertisement
110
REINSTALLING THE BACKHOE
9. Move the tractor backward until the support hooks on
the tractor main frame are just beneath the mount bars
on the backhoe main frame.
(1) Guide stop
(2) Mount bar
(3) Support hook
10. Lower the mount bars onto the support hooks by
operating the stabilizer and boom control levers.
11. Move the boom slowly to the lowering position, and
engage the guide plates of the main frame to the
bosses of sub frame. Then raise the rear wheels
slightly by operating the boom to the lowering
direction.
To avoid serious injury or death:
A Make sure pins are in all the way slide bar
secured and backhoe securely attached.
12. Shut off the engine. Reinstall the mounting pins, and
insert the slide bars of the mounting pins to the lower
hole of the main frame.
(1) Mounting pin
(2) Slide bar
A If the slide bar of the mounting pins is inserted to the
upper hole, the mounting pin comes off and the
backhoe might come off. Therefore, please make sure
to insert the slide bar to the lower hole.
A Move the tractor / loader / backhoe to an open area
and cycle all backhoe functions. This will check their
operation and flow oil back through the system,
filtering it and refilling each circuit. Check the hydraulic
oil level before putting the backhoe into full operation.
See "MAINTENANCE OF THE TRACTOR" section for
oil type and correct level.
Hide quick links:
Advertisement
Table of Contents
