Kubota BX25DLB Operator's Manual page 14

4 SAFE OPERATION
-
13. Set the implement lowering speed knob in the "LOCK"
position to hold the implement in the raised position.
(1) 3-point hitch lowering speed knob
3. PARKING THE TRACTOR
1. Disengage the PTO, lower all implements to the
ground, place all control levers in their neutral
positions, set the parking brake, stop the engine,
remove the key from the ignition and lock the cab door
(if equipped). Leaving transmission in gear with the
engine stopped will not prevent tractor from rolling.
(1) Brake pedal
(2) Parking brake pedal
2. Make sure that the tractor has come to a complete
stop before dismounting.
3. Avoid parking on steep slopes, if at all possible park on
a firm and level surface; if not, park across a slope and
chock the wheels.
Failure to comply with this warning may allow the
tractor to move and could cause injury or death.
(A) "FAST"
(B) "SLOW"
(C) "LOCK"
(A) "DEPRESS"
(B) "PUSH DOWN (2) WHILE
DEPRESSING (1)"
4. When parking your machine if at all possible park on a
firm, flat and level surface; if not, park across a slope.
Set the parking brake(s), lower the implements to the
ground, remove the key from the ignition and lock the
cab door (if equipped) and chock the wheels.
4. OPERATING THE PTO
1. Wait until all moving components have completely
stopped before getting off the tractor, connecting,
disconnecting, adjusting, cleaning, or servicing any
PTO driven equipment.
2. Keep the PTO shaft cover in place at all times.
Replace the PTO shaft cap when the shaft is not in
use.
(1) PTO Shaft cover
(2) PTO Shaft cap
3. Before installing or using PTO driven equipment, read
the manufacturer's manual and review the safety
labels attached to the equipment.
4. When operating stationary PTO driven equipment,
always apply the tractor parking brake and place
chocks behind and in front of the rear wheels. Stay
clear of all rotating parts. Never step over rotating
parts.
(A) "NORMAL POSITION"
(B) "RAISED POSITION"