Lutron Electronics FG-6020SD Operation Manual page 25

7-4 Set sampling time for peak record mode
When the lower display show " HSPt "
1) Use the "
▲
( 3-7, Fig. 1 ) to adjust the value ( adjust unit is milli
seconds, each step is 10 ms, setting start from 10 ms ).
After the desired value is set, press the " Enter Button "
( 3-6, Fig. 1 ) will save the setting value with default.
Remark :
The adjusted value range is from 10 ms to 500 ms,
2) After set the sampling time value, press the " SET
Button " ( 3-6, Fig. 1 ) once the screen will jump to "
Auto power OFF " setting screen ( Chapter 7-5 ).
7-5 Auto power OFF management
When the lower display show " PoFF "
1) Use the "
▲
( 3-7, Fig. 1 ) to select the upper value to " yES " or
" no ".
yES - Auto Power Off management will enable.
no - Auto Power Off management will disable.
2) After select the upper text to " yES " or " no ", press the
" Enter Button " ( 3-6, Fig. 1 ) will save the setting
function with default.
Button " ( 3-4, Fig. 1 ) or "
Button " ( 3-4, Fig. 1 ) or "
22
Button "
▼
Button "
▼