Timer; Dv 3 (Delayed Violation 3) - Aqua Lung i300C Owner's Manual

TIMER

The Timer function can be used throughout the dive. To add or remove the Timer from the Main display hold the
Alt button for 2 seconds. The Timer will cancel upon surfacing.
NOTE: Keep in mind that while the Timer is on the Main screen, Max Depth and Dive-T will be found on
the Alt 1 screen only. They will be restored to the Main screen if the diver removes the Timer from the
Main screen by holding the ADV button for 2 seconds. Additionally, Alarms will take priority over the
Timer function and will display in its place during the alarms.
add/remove Timer from
Dive Main screen

DV 3 (DELAYED VIOLATION 3)

If you descend deeper than the maximum functional depth*, the audible alarm will sound and the alarm LED will
flash. Also, the Up Arrow icon, UP message will flash, and Current Depth/Max Depth will only indicate dashes
signifying that you are Too Deep.
*The maximum functional depth, 100 M (330 FT), is the depth at which the i300C can properly perform calculations or provide accurate display
information. Refer to the Specifications in the back.
Upon ascending above the maximum functional depth, current depth will be restored, however, max depth will
continue to be displayed as dashes for the remainder of that dive. The Log for that dive will also display dashes
for max depth.
DV3 GAUGE
flashing
© Aqua Lung International, Inc. (2017)
min:sec to 59:59 (min icon not show-
ing), then min only to 999 (with min icon
showing)
start/stop Timer
LOG, DV3 GAUGE
violation
47
GAUGE MODE
Doc. 12-7874-r06 (11/27/17)