Advertisement
PRODUCT RECALL – END USERS (CUSTOMERS) – 7/21/2022
Dear Customer,
Aqualung Group is conducting a recall of its i330R Dive Computers that have been produced and distributed
in 2021 and 2022. It was identified that said dive computer does not automatically adjust pressure level
when diving at 900m (3000 feet) altitude or higher, posing an injury and drowning hazard. This product
recall is being officially announced on July 21, 2022, in cooperation with the U.S. Consumer Product Safety
Commission.
Instructions for Customers :
•
Customers should immediately stop using their i330R Dive Computer for diving activity taking place
at 900m (3000 feet) altitude or higher.
•
Customers are further asked to update their i330R dive computers by:
-
downloading a firmware update through DiverLog+ application as per instructions below; or
-
bringing i330R dive computer to the store where it was bought; the professionals of the
store/dive center will be able to download and install the upgrade.
After the installation of the update, the new firmware revision should read R1.004 or later.
End users upgrading their i330R themselves are advised to bring it to product dealer or local Dive Center
to check if the upgrade has been successfully installed.
If you have any questions, do not hesitate to contact customer service at the following address:
support@aqualung.com
Thank you for your understanding and unwavering support.
The Aqualung Team
i330R DIVE COMPUTER
Advertisement
Table of Contents
Related Manuals for Aqua Lung i330R
Summary of Contents for Aqua Lung i330R
- Page 1 After the installation of the update, the new firmware revision should read R1.004 or later. End users upgrading their i330R themselves are advised to bring it to product dealer or local Dive Center to check if the upgrade has been successfully installed.
- Page 2 IDENTIFICATION GUIDE FOR PRODUCTS CONCERNED BY THE RECALL & INSTRUCTIONS FOR DOWNLOADING AN UPGRADE i330R DIVE COMPUTER (WRIST) i330R 2-GAUGE PSI (CONSOLE) i330R 2-GAUGE BAR (CONSOLE) PRODUCTS CONCERNED BY THE RECALL CAN BE IDENTIFIED AS FOLLOWS: • 1) Product’s packaging label bears one of the following Description and Part Number (CPN):...
- Page 3 3. Confirm the Bluetooth is active on the mobile device and the i330R dive computer. 4. Run DiverLog+ app from your mobile device. 5. Instruction on how to add the i330R dive computer to the DiverLog+ are located at: https://ediverlog.com/howto/mobile_dlp_howto.html#AddNewDC Or scan the QR Code here: 6.
Need help?
Do you have a question about the i330R and is the answer not in the manual?
Questions and answers
unable to connect to phone/computer after upgrade. i300R