Configuring Computed Sources - Bosch C 80 Manual

12 | Analog and Frequency Inputs

12.3 Configuring computed sources

70 / 144
Available measurements for channel:
Measurement label
raw_name
raw_name_fi
name
name_fi
Note
Measurement of 'Revolution' is similar.
Computed sources receive data from a measurement channel rather than an input pin.
– Sensitivity/Offset calculation on input channel
– Characteristic curve calculation on input channel
– Computed vehicle speed
– Lap trigger (covered in a special separate section)
Example: Sensitivity/offset calculation on input channel
1. Click 'Measurement Sources' in the Toolbox.
2. Drag the 'Sensitivity/Offset' computed source from the Toolbox and drop it on 'Com-
puted Channels' in the C 80 Project Tree.
Drag + Drop
A 'Computed Sensitivity/Offset Wizard' opens.
Manual_C_80
Function
mV value of sensor
filtered mV value of sensor
physical value of sensor
filtered physical value
Bosch Motorsport