Advertisement
Quick Links
R10DS
(FHSS and DSSS spread spectrum)
Radiolink R12DS, 2.4G 10 channels receiver, DSSS and FHSS spread spectrum working
synchronously, compatible with Radiolink transmitters AT9, AT9S, AT10 and AT10II.
Two signal working mode:
Red LED always, SBUS and PWM signal working at the same time, 10 channels totally.
(1) PWM signal output: PWM signal output from row 1 to row 10(CH1 to CH10).
(2) SBUS signal output : row eleven support SBUS signal output.
Advertisement
Related Manuals for RadioLink R10DS
Summary of Contents for RadioLink R10DS
- Page 1 R10DS (FHSS and DSSS spread spectrum) Radiolink R12DS, 2.4G 10 channels receiver, DSSS and FHSS spread spectrum working synchronously, compatible with Radiolink transmitters AT9, AT9S, AT10 and AT10II. Two signal working mode: Red LED always, SBUS and PWM signal working at the same time, 10 channels totally.
- Page 2 3. Connect CH3 of R10DS to ESC. 4. There is a black button on the R10DS, use a thin stick press the button twice in two seconds and release, receiver light start blinking, after about 8 times blinking, match code success when receiver signal LED always on! Installment of receiver antenna：...
- Page 3 3. Large model aircraft may has some metal part interfering signal; in this case the antennas should be placed at both sides of the model. Then the best RF signal condition is obtained at any flying attitude. 4. The antennas must be kept away from conductive materials, such as metal and carbon. at least a half inch.
- Page 4 Connect to telemetry module PRM-02 Specification: 1) Channels: 10 channels: output 10 channels signal, support SBUS and PWM signal output synchronously, with red LED. 2) Working voltage: 4.8-10V 3) Working current: 38-45mA（input voltage: 5V） 4) Size: 50*31.5*14.5 MM 5) Weight: 14g 6) Receiver integrate telemetry sensor including signal strength and voltage.